You can override this default behavior by configuring an MC-LAG interface Mode, a link switchover happens only if the active node goes down.
![software lag switch software lag switch](http://smrenew.weebly.com/uploads/1/2/4/9/124910408/996751691.jpg)
With this configuration, you can trigger a link switchover to a preferred In active-standby mode to automatically revert to a preferred node. Node even when the active node is available. Bonacell Wireless Switch Controllers Compatible with Nintendo Switch/Lite/OLED Game Console, Switch Pro Controller. Software Lag Switch is an utility that allows you to slow every computer on the network or just. PE1 is configured in active mode making itĪ preferred node, and PE2 is configured in active-standby mode. Software Lag Switch version 1.1 (Software Lag Switch.exe). Triggered and the control is switched back to PE1 even though PE2 However,Īs soon as PE1 is available again, an automatic link switchover is InĬase of any failure at PE1, PE2 becomes the active node. You can configure the link switchover in two modes: revertiveĪnd nonrevertive.
![software lag switch software lag switch](https://venturebeat.com/wp-content/uploads/2020/03/aiskinshine.jpg)
#Software lag switch manual
Time that triggers an automatic or manual switchover when the specified In nonrevertive mode, the link switchover In revertive mode, the link switchover is triggeredĪutomatically by using the request interface mc-ae switchover operational mode command.
![software lag switch software lag switch](http://appgawer.weebly.com/uploads/1/3/3/0/133066399/533735082_orig.jpg)
That you perform switchover by entering the request interface With a Layer 2 circuit local-switching configuration, we recommend Of both the MC-LAGs and when both mc-ae interfaces are linked together Switchcover mode is configured on the aggregated Ethernet interfaces Setup using Inter-Chassis Control Protocol (ICCP) and nonrevertive If two MC-LAG devices configured in an active-standby LAG SWITCH SOFTWARE MANUAL